Search: Browse by Category:
FAQ Main Page
ASK QUESTION
View Questions by Category:

General (5)Living Waters Mission Development (4)Water Issues Survey (0)
Clean Water Covenants (2)Living Waters Sustainability (0)Water Quality (32)
Water Supply (1)Living Waters Supply Chain Management (0)Living Waters Installation Building (0)
Electrical (5)Reverse Osmosis and Softening (10)Solar Power (1)
Bottling Issues (2)Regulatory Compliance (0)Clean Water U (1)
Standard Board (12)Health & Hygiene Education (6) 
 
Top 5 Articles
How do I get started with Living Waters for the World (LWW)?
If your church or organization is interested in starting or upgrading its mission and outreach program, Living Waters for the World has a program for you.  A good starting place for someone ......
Not Rated Last Update: 2008-07-09 Views: 10
The “Operating Partner” we are working with has no access to a water source. We want to help them drill a well and install a pipeline to their church. Can Living Waters help us?
The Living Waters for the World Mission trains and equips others – individuals, church teams, service groups, and other organizations – in the front-line skills necessary to transform available, but contaminated, ......
Not Rated Last Update: 2008-07-11 Views: 9
What if an installation team comes up with a better design idea for the standard board?
The Living Waters for the World Technology Team and Design Sub-team welcome technical input and advice on a better designed water system.  It is important that these teams review the design thoroughly and ......
Not Rated Last Update: 2009-05-18 Views: 7
The Mascontrol Pump Controller I purchased from FCI is not wired. How do you wire it for the standard ROS system?
The Mascontrol Pump Controller is a dual voltage 115/230 VAC unit that comes unwired from the Fulfillment Center (FCI).  In order to control the raw water pump, this controller must be ......
Not Rated Last Update: 2008-07-02 Views: 7
How much does CWU cost?
CWU costs $600.  If teams send three or more members, the cost for each is reduced to $550.  Some scholarships are available for International students.  Please check with the Living Waters ......
●●●●● Last Update: 2009-04-26 Views: 7
Last 5 Articles
What information can I get from the pressure gauges on the Big Blue filters?
1.  You must read the pressure gauges while the system is running to get a true picture of how the filters are doing.  2.  When you see a reading of: ......
Not Rated Last Update: 2009-10-27 Views: 1
What if my pump is too large for the water system? Can I adjust it by installing valves on the pump suction and discharge lines to control the flow?
First, best practive is to never throttle a pump from the suction side, always on the discharge side.  Starving the pump for water will damage the bearings, generate excessive heat inside ......
Not Rated Last Update: 2009-07-07 Views: 1
Does Living Waters have a standard design for a solar powered system?
Living Waters does not have the technical resources to develop a standard design for a solar powered system.  One of our Initiating Partners, however, has developed a solar powered system for ......
Not Rated Last Update: 2009-05-18 Views: 5
Describe how the bottles are used. Where do you get them? Do you reuse them or only use new ones each time? Is there a cap or sanitary seal?
Internationally bottles are purchased in country.  They are 20 liter bottles and are very definitely reused.  In our 103 Clean Water Systems Handbook, chapter 12 - and elsewhere - is devoted ......
Not Rated Last Update: 2009-05-18 Views: 1
Can UV units be left on for long periods of time?
Yes.  In fact, if possible, the unit should be left on 24/7.  The only time a problem can occur is when you have a UV intensity monitor.  The heated/hot water created while the ......
Not Rated Last Update: 2009-05-18 Views: 1